Initially of all, we want the P7 to become in a position to insert the SD card since he has a unique card tray along with the induction position from the SD card and also the SIM is different. The electrode contacts of your SIM card plus the SD card from the mobile telephone will not be shared and are distributed in distinct positions. The two cards The golden finger has the opportunity to stagger the position and connect at the identical time. So we can retain the valid component from the SIM and paste it on the SD card and then study it at the very same time.
Based on this idea, we should select the SD card with fantastic excellent, the goal should be to stay away from harm caused by repeated reading and writing, and need to re-fit operation. The plastic portion of the SIM card should also be completely removed, which is a delicate manual perform. google are as follows:
1. Recall exactly where the sim card and sd card must be following they are installed; otherwise, it can be effortless to confuse the position relationship following taking down the sim card. Prior to removing recovery software from the plastic tray, initially check the position, it truly is greatest to leave a reference for the photo, otherwise it truly is effortless to produce the position partnership incorrect right after removing it.
2. Eliminate the sim card, soak the NANO card with xylene or pine perfume for five minutes, eliminate the NANO card and manually peel off the plastic part of the NANO card (this method is the simplest and does not harm the SIM card). Or use a hair dryer to blow the nanosim card, and use eyebrow pliers to very carefully peel the nanosim card chip from the soft glue; the middle part with the NANO card chip is a little convex, as well as the convex part in the middle part in the transparent glue is thinned with an electric iron. Which is, so long as the transparent layer of glue on the chip is flattened slightly bit, because you can find six very thin copper wires around the chip, it will break if you're not careful.
The latest nanosim card, the chip part is significantly smaller than the old card. In case your card is stripped out and wider, the two sides may perhaps be short-circuited with all the metal frame of your card tray soon after installation. It is encouraged to cut each sides 1mm to avoid each sides from the sim card Speak to with the card tray, (observe very carefully whether or not the two sides in the card are away from the metal frame) to stop short circuit. The sim card is very straightforward to reduce, like cloth.
3. Use AB glue to glue the sim card chip as well as the sd card well (or use the earphone model transparent soft glue, no corrosion and no whitening. 502 glue is not encouraged since it is corrosive).
Comentários